Ezgo ST 400 CARB Owner's Manual download pdf (Page 29)

OPERATION AND SERVICE INFORMATION

Page 9

Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings.

When using a load bed, be sure to avoid backing up to

the edge of a drop off, such as a loading dock or ravine.

A misjudgment of distance or an unstable surface could

result in the vehicle falling backwards.

MANUAL LIFT BED

Exercise caution while operating the manual lift

bed to ensure the bed is not released during

lifting or lowering procedure. Severe injury

could result if bed is released and traps fingers

or other body parts.

To lift the manual lift bed, pull back on the latch release

handle immediately behind the driver seat (Ref. Fig. 15

on page 9). Raise the bed using the handle on the side

of the bed.

On the ST 400, the gas strut will assist in raising the

empty load bed and will keep the bed raised (Ref. Fig.

16 on page 9).

Over time, the gas strut may allow the load bed to slowly lower.

If this condition is evident, replacement of gas strut is required.

To lower the manual lift bed, grasp the bed handle and

lower the bed to the rest position. Be sure hands are

not trapped by the bed.

TAIL GATE OPERATION

To open the tail gate, lift tail gate straight up with a sharp

upward pull to lift out of the closed position and pivot out

for open position. To remove the tail gate, remove the

side cables from the load bed and open tail gate until it is

straight down, move tail gate panel straight up to remove

from pins and remove from the load bed. Reassemble in

reverse order.

Never fill a gas can in the bed of a vehicle.

Static discharge could ignite gasoline vapor

and cause an explosion.

Always place a gas can on the ground before filling.

Never fill a gas can in the bed of the vehicle. Static elec-

tricity is built up during the fueling process and could

discharge causing the gasoline vapor to ignite.

ELECTRIC LIFT BED OPERATION

(ST 400 Only)

Exercise caution while operating the electric lift

bed to ensure clothing is not caught during lift-

ing or lowering procedure. Severe injury could

result if bed is lowered and traps fingers or oth-

er body parts.

The electric lift switch is located on the driver side of the

front seat panel (Ref. Fig. 17 on page 10). Move the tog-

gle switch lever up to raise the load bed and down to

lower.

Before operating load bed, check to ensure no one is

behind the vehicle.

Fig. 15 Manual Bed Latch

Ref Mbl 3

ront of Vehicle

Manual Load Bed Latch

Pull Up to Release

Fig. 16 Gas Strut with Tether Cable

Ref Gss 1

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 163 164

Comments to this Manuals

No comments

Ezgo ST 400 CARB Owner's Manual Page 29

Comments to this Manuals

Related products and manuals for Cars Ezgo ST 400 CARB